Reading Room · Last Chapter Coffee Blog

Chemex Brew Guide: How to Brew a Clean, Sweet Pour-Over

By Rogee Sirajeldin ·October 15, 2026

Chemex Brew Guide: How to Brew a Clean, Sweet Pour-Over

The Chemex is the most elegant way to make coffee and one of the least forgiving — but the learning curve is short, and the payoff is a cup so clean it tastes like it was filtered through glass, because it was. Here is the complete method.

What You Need

  • A Chemex brewer (6-cup is the most versatile size)
  • Chemex bonded filters (thicker than standard — this is the whole point)
  • 30g whole coffee beans and a grinder, or 30g pre-ground coffee
  • A gooseneck kettle
  • A scale (timers and guesses both fail here; a scale doesn't)

The Recipe: 30g Coffee to 500g Water

That is a 1:16.7 ratio, the sweet spot for Chemex. It makes about two large mugs. For the full ratio logic across all brewers, see our coffee-to-water ratio guide.

Grind: Medium-Coarse, Like Kosher Salt

This is where most Chemex failures start. The thick bonded filter slows the drawdown, so a grind that is too fine will stall the brew and turn the cup bitter. Aim for kosher-salt texture — coarser than a standard drip grind. If your cup tastes weak and your bed looks soupy, go finer; if it tastes harsh and drains past 5 minutes, go coarser. Our coffee grind size guide has a visual reference.

Step by Step

1. Rinse the filter. Open the filter, thick side against the spout, and rinse with hot water to wash away paper taste and preheat the brewer. Dump the rinse water completely.

2. Add 30g of coffee. Tap the brewer to level the bed.

3. Bloom: 60g water, 45 seconds. Pour 60g of just-off-boil water (about 205°F) over the grounds and wait 45 seconds. Fresh coffee will swell and bubble — that is CO2 escaping, and skipping this step is the fastest route to a sour cup.

4. Pour to 200g by 1:15. Pour slowly in concentric circles, keeping the water level steady. Avoid pouring directly onto the filter paper.

5. Pour to 350g by 2:15, then to 500g by 3:00. Three total pours is the simplest rhythm that works. Each pour agitates the bed just enough for even extraction.

6. Let it draw down. The last drips should fall around 3:45–4:15. Swirl the Chemex, pour, and drink it fresh — Chemex coffee fades fast as it cools.

Troubleshooting Your Brew

  • Sour or thin: grind finer, or your water was too cool.
  • Bitter or harsh: grind coarser, or shorten the total time below 4 minutes.
  • Stalled drawdown past 5 minutes: your grind is too fine for the bonded filter — the single most common mistake.
  • Flat, lifeless cup: the coffee is stale. Chemex punishes old beans more than any other brewer because there is nowhere for staleness to hide.

Which Coffee Works Best in a Chemex?

The Chemex highlights clarity and sweetness, so choose beans with those qualities. Bright, washed coffees shine: Guatemala and Costa Rica are natural fits, and Colombia gives you a rounder sweetness. For an everyday brewer-friendly option, House Blend brews clean and consistent. Compare the technique with our pour-over for beginners guide.

Brew like the filter demands fresh beans. Order fresh-roasted coffee — roasted to order, never warehoused — and take 10% off with code WELCOME10.

Share: X Facebook Pinterest